MATTE, WRAP, AND PPF CERAMIC COATING
.jpg&height=220)
Evolution's Matte, Wrap & PPF Ceramic Coating is an advanced solution that provides unmatched protection for your vehicle's vinyl wrap, matte paint, and paint protection film. Made with state-of-the-art ceramic technology, this coating creates a hydrophobic and oleophobic layer on your vehicle's surfaces, making them incredibly resistant to water, dirt, and other contaminants. Unlike traditional coatings, this ceramic coating is designed to maintain the unique look and texture of your vehicle's wrap, PPF or matte paint. The coating provides long-lasting protection against UV rays, environmental contaminants, and other types of damage.
Available in 30ml and 50ml bottles.
Each purchase also includes a High Quality Suede Applicator.
Free Shipping on all orders
DIRECTIONS: Take a fresh application pad and dampen with the ceramic coating until it is wet, but not dripping. Coat one area or up to 2 square metres at a time, ensuring on each panel to work horizontally, then vertically, for an even spread of product (also known as cross-hatching). The area should look wet and have a rainbow appearance after approximately 30 seconds to 1 minute. After a minimum of 1 minute, but not exceeding 2 minutes take a clean microfiber cloth and go back to the point where coating started.
Gently buff all the areas that have been coated in order to remove the excess residue, until a uniform streak free appearance is achieved. Ensure the buffing process is light and only excess residue is being removed. Use a second micro fiber cloth for complete residue removal for a quality finish. Once you have finished buffing, repeat the process continuing as above.
TIP – If the product has been left on for too long and is difficult to remove, re-wet the area with an application pad and instantly buff with a microfiber cloth. Do not allow to cure with streaks and rainbows! a paragraph.
Gently buff all the areas that have been coated in order to remove the excess residue, until a uniform streak free appearance is achieved. Ensure the buffing process is light and only excess residue is being removed. Use a second micro fiber cloth for complete residue removal for a quality finish. Once you have finished buffing, repeat the process continuing as above.
TIP – If the product has been left on for too long and is difficult to remove, re-wet the area with an application pad and instantly buff with a microfiber cloth. Do not allow to cure with streaks and rainbows! a paragraph.
.jpg&height=292)
